My design- Step-by-Step

STEP-BY-STEP

-MY DESIGN-

You need:

• Paddle brush
• Pin tail comb
• Sectioning clips
• Hair pins ( a whole lot of them)
• Kirby gribs
• Heat protection
• Hair spray
• Hair wax
• Hair straightener
• Crimping iron

->       Apply heat protection and brush the hair àmake sure there are no knots

->       Section the hair in 3 sections, 1: front->triangle shape->for frizzing, 2:middle for crimping, take the section down to the ears->make sure the sections are the same on each side otherwise there will be problems later when putting up the hair, 3: back-> for wiggly plaits

->       Start with crimping all of the hair from the 2^nd sectionàthen backcomb it a lot until it stands on its own J have to be able to create a ‘heart’ shape without paddingàwould suggest to make a lot of small sections for the crimping and backcombing to get a lot of volumeàwhen everything is backcombed take it over and secure it with hair pinsàtake everything right up to the middle so there is no gabàdon’t roll it in too much while you take it overàfix flying hair with hair spray and baby hair with hair wax

->      Now go to the front and separate the section in 2 rowsàto frizzing using the hair pin-hair straightener method(take hair pin and wind hair in an eight motion around it, secure by heating it up with hair straightener)àleave the hair pins in until the hair is cooled down

->       While letting the frizzing cool down go to the back and do the wiggly plaitsàHOW TO DO WIGGLY PLAITS: take a strand of hair and plait it like a normal plait, but not too tight, then take 2 strands of it to one side and push them up on the single one getting this kind of pattern

-> Do wiggly plaits around the back of the head in a random order

->       Go back to the front and take out hair pinsàtake frizzed hair apart and backcomb it if necessary àthen take it up and over and secure with hair pins->use hair spray if necessary